Read Featured Reviews From Actual Customers Read All Reviews
Boost Signal for Any Vehicle
Whether it’s a car, SUV, truck, the family's minivan, or even a little hatchback, the Bolton Velocity will make sure you have signal anywhere on the road. It installs right under the driver's seat, taking up little to no space and boosting signal throughout the interior of your vehicle. Keep your driver and passengers connected with strong, stable voice and data.
The Bolton Velocity Vehicle is the powerful mobile signal booster kit on the market, guaranteed to bring better signal to your vehicle. Its massive +50 dB gain - the highest legally allowed by the FCC - ensures superior reception, even with weak outside signal. Cruise cross-country and discover untold adventures, all while never dropping a call.
Meet the Mighty Mag Mount 4" Antenna
Our Velocity Vehicle signal booster kit comes with a Bolton Technical Mighty Mag mount antenna. This small, powerful 4" omnidirectional antenna is unassuming enough for your every day ride, yet powerful enough to give the boost you need. The Mighty Mag captures existing cellular signal and sends it to the Velocity boosting. The result? Better cell reception, even in challenging environments.
Eliminate Dropped Calls and Slow Data
The Bolton Velocity Vehicle booster kit boosts 4G LTE cellular even in remote areas, providing reliable voice and data. If there is any cell signal outside, it will be amplified. Dropped calls will be a thing of the past, letting you keep in touch wherever the road takes you.
No WiFi is needed, nor are there any monthly fees - simply buy, set up, and go. You'll be amazed at the difference!
Simple Vehicle Setup
Installing the Velocity vehicle booster kit is a breeze. Place the Mighty Mag outdoor antenna on top of your car with the super strong magnet mount. Place the booster under a seat or inside your center console in a well-ventilated area. Plug the provided cable from the antenna into the booster and then to the inside antenna. You're ready to go!
The Bolton Velocity vehicle cell phone booster standard kit has everything you need to connect any vehicle to great signal on the go. Install it in your SUV, minivan, truck or even hatchback in a few simple steps. Cruise the country with peace of mind that you have good reception no matter where you go.
The Bolton Velocity vehicle cellular booster has a maximum gain of +50 dB. This is the most allowed by the FCC in the US. The Velocity boosts 4G LTE cellular voice and data for every carrier (Verizon, AT&T, T-Mobile, and more), with 5G data covering low-band Verizon and AT&T.
The outdoor Mighty Mag antenna by Bolton Technical stands only 4 inches tall and has a super powerful magnet mount base. It offers up to 3.1 dBi gain, drawing in even a weak 4G signal. It is discreet enough for your everyday ride, and powerful enough to keep you connected even in challenging signal areas.
Installing the whole kit is as simple as mounting the outside antenna, running the cable to your Velocity booster, installing it under your seat or in your console, and connecting it to your inside antenna. Everything you need is included in the kit. No mess, no hassles, no extra wires.
- +50 dB Bolton Velocity signal booster
- +3.1 dBi outdoor antenna
- Better data speeds and less dropped calls
- Boost 4G LTE on the go to all vehicles
- 5G ready
- Easy installation
- Complete kit
The Bolton Velocity signal booster kit amplifies existing outdoor signal inside your vehicle.
- The outdoor antenna draws in existing cell signal
- The signal is sent via cables to the signal booster or cellular amplifier
- The signal is then sent to the inside antenna which broadcasts into the cabin of your vehicle
- Bolton Velocity Vehicle Booster Part # BT459624
- Outside 4" Mighty Mag FME 5G Antenna Part # BT459914
- Inside Flat Antenna - FMEBT459679 Part # BT459679
- Accessory Mounting Packet
- Power Supply BT459815
- Connector FME-Female to SMA-Female Part # BT512037
- Power Supply-DC Part # BT459815
|Bolton Velocity Vehicle Kit|
|Input/Output Impedance||50 Ohm|
|Maximum Gain||50 dB|
|Max Uplink Power||29 dBm|
|Noise Figure||≤5 dB|
|Gain Adjustment||20 dB (Automatic)|
|Maximum Output Power||1 Watt EIRP|
|Cable Type Outside||RG-58U|
|Cable Type Inside||SC-174|
|Outside NMO Antenna Cable||17 feet|
|Inside Patch Antenna Cable||10 feet|
|Hardwire Power Supply Cable||18 feet|
|RF Connectors||FME male (both ends)|
|Dimensions||6.58" x 4" x 1.125"|
|FCC NOTICE||This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by FCC or a licensed wireless service provider.|
|WARNING: California's Proposition 65||This product can expose you to chemicals including Nickel (Metallic) which is known to the State of California to cause cancer and Bisphenol A (BPA) which is known to the State of California to cause birth defects or other reproductive harm. For more information go to https://www.p65warnings.ca.gov/.|
1. Install the Outside Antenna
Place antenna on top of vehicle, toward the back
Run cable across vehicle roof and inside.
Place cable in door seal.
2. Install the Inside Antenna
Find a location for the inside antenna. We recommend placing it:
Within 2-3 feet of typical cell phone location,
At least 8 inches (20cm) from cellular devices,
At least 4 inches (10cm) from metal.
Attach it with the included velcro or vent clip.
3. Place Booster and Connect Cables
Place booster in a well-ventilated location. We suggest beneath a seat or within the front console.
Connect the cable from the outside antenna to the connection marked OUTSIDE and the cable from the inside to the connection marked INSIDE.
4. Connect Power
Connect the DC power cord to your vehicle’s cigarette lighter and attach it to the booster. Power on.
Frequently Asked Questions
The Velocity is 5G ready, which means that it can boost data up to 5G speeds. It is future-proof and will work with new technologies.
As the Velocity works via the cigarette lighter in your vehicle, it will differ from car to car. Some vehicles will power the booster with the ignition on, while some will work even with the car completely off.
Yes. For any signal booster to work you need at least one bar of outside signal.
Each Velocity kit comes with a different set of antennas. The standard kit (BT459624-M) has a Mighty Mag magnet mount antenna and an inside flat panel antenna. The trucker kit (BT459624-T) has an outside Blade antenna and an inside flat panel antenna. The RV kit (BT459624-RV) has an outside Blade antenna and an inside whip antenna.
Firstly, make sure your inside and booster are far enough away from each other. If that still doesn’t work, make sure all your cables are connected properly. Make sure there is enough signal where your outdoor antenna is set up. If there is still no boosted signal give us a call on 1-800-470-6777 or email email@example.com.