weBoost (Wilson) 971109 N-Male Crimp for Wilson400
weBoost (Wilson Electronics) 971109 N-Male Crimp for WILSON400 Cable
The Wilson 971109 is a N-Male Crimp Connnector designed to make WILSON400 cables or non-wilson coaxial cables with N-Male connector. This connector attenuates signal by 0.1 dB.
- Designed to make WILSON400 cables or non-wilson coaxial cables with N-Male connector
- Wilson 971109 N-Male Crimp
- Frequently Asked Questions (FAQ) page
- Home & Building Cell Phone Signal Booster Kits
- Car & Vehicle Signal Booster Kits
- Frequencies By Cell Service Provider
Signalboosters.com is an official reseller of weBoost. Email us at firstname.lastname@example.org or call 1-800-470-6777 if you have any questions or comments. Our friendly Texas-based certified customer support is ready to help and serve.
1: Stripping the Cable
Using wire cutters, cut off the end of the cable. Using wire strippers, remove about 1/2 inch of the cableÎ__ÎÎÇ_s cover to expose the bare copper center. Using your fingers, expose about 1/8 inch of braid and foil by pulling off a small piece of the outer jacket.
2: Preparing the Wire
Slip the crimp ring over the end of the cable. Use your fingers to bend all of the braid back along the outside of the cable as evenly as possible.
3: Attaching the Connector
Push the stripped cable end into the connector so that the connector tube goes between the foil and outer housing of the cable. Push the end until the insulator is flush with the bottom of the connector. Slide the crimp ring over the bottom of the connector.
4: Crimping the Connector
Crimp the connector ring tightly around the end of the connector using a crimping tool.
5: Completing the Task
Trim the loose wires and cut the copper core wire flush with the connector end. Check connector attachment firmness by pulling on the connector and cable. Repeat the process for other cable ends needing connectors.